Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I think it's means the subcircuit "sram" you defined have 60 nodes.but when you call the subcircuit.you only define the 34 node.
the syntax of subcircuit definition is :
.subckt CircuitName node1 node2 ......noden
...
...
.ends
the syntax of call the subcircuit is:
Xn node1 node2 .....noden SubcktName
That's means the number of the node you call a subciruit must same as the subcircuit definition.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.