saviour2009
Newbie level 3
- Joined
- Feb 15, 2010
- Messages
- 3
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Bangalore
- Activity points
- 1,303
Hi,
I want to save the S parameters for a two port network to a floppy disk drive using a HP8753D network analyzer. I can do it if I save the data to a floppy disk without performing the calibration.
But when I recall the calibration state stored in one of the internal registers, I see that the system shows "Waiting for Clean Sweep" and "Saving: Data Array" and responds to nothing going into a hanged state.
Any suggestions would be greatly appreciated, as it has really made my project come to a standstill.
Thanks..!!
I want to save the S parameters for a two port network to a floppy disk drive using a HP8753D network analyzer. I can do it if I save the data to a floppy disk without performing the calibration.
But when I recall the calibration state stored in one of the internal registers, I see that the system shows "Waiting for Clean Sweep" and "Saving: Data Array" and responds to nothing going into a hanged state.
Any suggestions would be greatly appreciated, as it has really made my project come to a standstill.
Thanks..!!