Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to use ioupdate signal in ad9910 device

Status
Not open for further replies.
K

kishorevarma.k

Newbie level 2
Joined
Sep 19, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
10
HI

IOupdate signal can be sent once after each register such as CFR or FTW or some other registers which you what to configure are configured serially

Example

CFR register

serially
adress register 00000000
data register 00000000000000000000000000000000
ioupdate 10

correct me if i am wrong
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top