Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to use 'idfrd' system object as a channel model in simulink

Status
Not open for further replies.
G

glodi

Newbie level 1
Joined
Jan 5, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Hello dear members,

I have created an idfrd object using measured frequency response data (using Magnitude/Angle measurements). Now I want to incorporate this data into a continuous time SISO model, which I can place as the channel between Tx/Rx in a communication system simulation.

I have tried using 'LTI system' block from Control System Toolbox library, but it does not support idfrd system object.

What can I do now? Is there any alternative way to address this issue? I am using Matlab/Simulink 2014a.

Thanks!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top