glodi
Newbie level 1
Hello dear members,
I have created an idfrd object using measured frequency response data (using Magnitude/Angle measurements). Now I want to incorporate this data into a continuous time SISO model, which I can place as the channel between Tx/Rx in a communication system simulation.
I have tried using 'LTI system' block from Control System Toolbox library, but it does not support idfrd system object.
What can I do now? Is there any alternative way to address this issue? I am using Matlab/Simulink 2014a.
Thanks!
I have created an idfrd object using measured frequency response data (using Magnitude/Angle measurements). Now I want to incorporate this data into a continuous time SISO model, which I can place as the channel between Tx/Rx in a communication system simulation.
I have tried using 'LTI system' block from Control System Toolbox library, but it does not support idfrd system object.
What can I do now? Is there any alternative way to address this issue? I am using Matlab/Simulink 2014a.
Thanks!