how to use Force/release in UVM

Status
Not open for further replies.
A

arunramnath

Junior Member level 1
Joined
Apr 2, 2010
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Austin
Activity points
1,386
I know we cannot use the force/release statements directly in an UVM run phase because of the interface based communication between TB and DUT.

In case I need to force a pin A in the DUT to logic 1, How can I go about it ?

I could not find any source to get this info.
 

Create a task in your interface to do the force/release, then call the task from your driver. If the DUT signal is unrelated to any existing interface, you may need to create a separate interface and use bind to instantiate the interface inside your DUT. See my **broken link removed** that shows a few ways to do this.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…