msdarvishi
Full Member level 4
How to set a trigger to srart and a trigger to stop sampling in ChipScope Pro Analyze
Hello,
I am using ISE14.7 targeting a Virtex-5 FPGA and I would like to configure ChipScope Pro Analyzer to start sampling data with with rising edge of a signal and stop sampling data with rising edge of another signal. I have a screen shot of ChipScop Pro Core Inserter in the following. I think I have to define two trigger points, one for start sampling and one for stop sampling data, but I do not know how to set their Match Type parameter in the ChipScope Pro Core Inserter??
Kind replies and helps are cordially appreciated.
Regards,
Hello,
I am using ISE14.7 targeting a Virtex-5 FPGA and I would like to configure ChipScope Pro Analyzer to start sampling data with with rising edge of a signal and stop sampling data with rising edge of another signal. I have a screen shot of ChipScop Pro Core Inserter in the following. I think I have to define two trigger points, one for start sampling and one for stop sampling data, but I do not know how to set their Match Type parameter in the ChipScope Pro Core Inserter??
Kind replies and helps are cordially appreciated.
Regards,