Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to model a button cell in CST Microwave Studio?

Status
Not open for further replies.
M

matianfu

Newbie level 3
Newbie level 3
Joined
Sep 13, 2008
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,310
I want to simulate (and design) an antenna for 2.4GHz Active RFID in CST microwave studio.

There is a button cell near the antenna. Most area of the outer case is anode, that is, the power, not the ground. So I wonder how to model it in simulation software. Is it OK to simply create a metal cylinder? Or the battery is something mysterious in microwave and if I want to get an accurate result, I had better to use an metal case to surround the cell?

Any advice?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top