ranco980
Newbie level 4
Hi,
i am making a board with a video chip and in the recomended circuit there is a coil components that is suppose to between 0.1 to 0.4n. this component has a note that says:
* Formed by the printed circuit pattern (L = 0.5 to 1.0mm/W = 0.5 to 1.0mm)
i was wondering how exactly i do that, i never made a coil using the PCB traces before!
Thx and BR
Ran.
i am making a board with a video chip and in the recomended circuit there is a coil components that is suppose to between 0.1 to 0.4n. this component has a note that says:
* Formed by the printed circuit pattern (L = 0.5 to 1.0mm/W = 0.5 to 1.0mm)
i was wondering how exactly i do that, i never made a coil using the PCB traces before!
Thx and BR
Ran.