nxt_
Member level 4
Dear all,
Greetings, i would like to know how to isolate between tracks in altium 10 designer after finishing the pcb, i mean like in Eagle. (after you finish the routing and everything you just set the ratio and the program do the rest.) so i am asking how to do that in altium.
i am using photo resist technique as pcb manufacturing process. so i need to output file with holes ,vias,tracks including isolation to be printed.
Thanks.
---------- Post added at 01:38 ---------- Previous post was at 01:28 ----------
sorry its altium 09 not 10..
Greetings, i would like to know how to isolate between tracks in altium 10 designer after finishing the pcb, i mean like in Eagle. (after you finish the routing and everything you just set the ratio and the program do the rest.) so i am asking how to do that in altium.
i am using photo resist technique as pcb manufacturing process. so i need to output file with holes ,vias,tracks including isolation to be printed.
Thanks.
---------- Post added at 01:38 ---------- Previous post was at 01:28 ----------
sorry its altium 09 not 10..