Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to initialize lcd using coldfire processor

Status
Not open for further replies.

s3034585

Full Member level 4
Joined
May 24, 2004
Messages
226
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Activity points
2,087
coldfire with lcd

hi guys

i am using a 5282 coldfire processor and trying to interface a 2x8 lcd with hd44780 controller. i am trying to use the general purpose io pins from 5282 processor and have written a simple code just to initialize the display but it is not getting initialized. i am able to write the data on the gpio successfully. I tested it by putting leds.


can any one pls tell me what can be the possible problem.

thanks a lot...
tama
 

hi
thanks for ur reply... there was some timing problem in the code. now the lcd is working fine.

thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top