Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Now, I am trying to connect led bar, but the current not enough
The current now is only 0.1mA, I would like to increase to 1A........what can I do? I tried to make amplifier current but not used, not enough power supply to IC and regulator
You need to use some magic to increase current of your generator because its output is very weak.
If you amplify its output then the amplifier's output power must come from a big battery or from a power supply so then you should throw away your generator and use the battery or power supply instead.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.