tyassin
Advanced Member level 1
maxdxf.ini
Hi
If you make a hybrid coupler or wilkinson power divider in ADS layout, is it possible to have this imported into Orcad.
Here I mean to have it as an component with ports so I can use it in Orcad Capture?
Hope this make sense.
Regards
Hi
If you make a hybrid coupler or wilkinson power divider in ADS layout, is it possible to have this imported into Orcad.
Here I mean to have it as an component with ports so I can use it in Orcad Capture?
Hope this make sense.
Regards