Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to give the DC sweep from 40V to 0V a decremental sweep in Orcad Pspice?

Status
Not open for further replies.
A

akhilmukund

Newbie level 5
Joined
Dec 28, 2009
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
India
Activity points
1,341
In Orcad Pspice simulator how to give the DC sweep from 40V to 0V a decremental sweep (incremental sweep is working).Plz help

thanks
akhil
 

DC Sweep

The same as incrementing but the start value is 40, the end value zero, and a negative step.

Keith
 

Re: DC Sweep

i tried that too. but its also starting from 0 to 40 only. Is there any test bench method which i can code and run the file.

akhil
 

DC Sweep

Are you sure it isn't simulating the correct way round? My simulator will sweep both ways but the x axis will always show low to high numbers, left to right on the plots.

A useful check is a comparator with hysteresis.

Keith
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top