Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to draw an arc of width W and length L??

Status
Not open for further replies.
A

ant_ebg

Newbie level 6
Joined
Jun 3, 2011
Messages
14
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,283
Location
The world has no boundaries...
Activity points
1,358
Hi everybody,

Can anybody give me some tips about drawing an arc in HFSS v.10.

I want to draw parasitic arc beside patch or slot inside patch etc.

Appreciate any helps.... :)
 

In the version of BASIC I use, the syntax for drawing an arc uses the command for drawing a circle. You add a term or two for the beginning and end angles.

Does your language have a similar command?

Or can you draw a circle, and then draw something invisible over the extraneous part of the circle?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top