Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Open ADEXL then go to add corner setup on the side. the at the bottom it will say import PCF/DCF. Find your PCF file and it will load and you will have your corner setups ss at 125C or 85c and ff -40c and nn 20c.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
