I am using pads 2005 sp2 tool for designing the baords. Now a days the customer are asking with arc routing pattern instead of 45 degree. Is there is any option to route the traces with ARC routing pattern . I have tried it with convert to arc option but it takes a huge time for converting traces to arc for each segment in the trace . Is there any option for ARC routing option as same as allegro.
I have encountered the same problem of transforming the 45-degree cornered traces into arcs with PADS 2005/2007. There seems to be no easy of doing it with the software. What you can only do is to go to every corner of the trace and do a "pull arc" command, but that's too tedious and time consuming.... unless other PADS users here might have a better or faster way of doing it..
In my design there are some differential pairs with ARC routing to be matched exactly.If so how could I do it by using PADS software. Almost more than 50 pairs to be matched exactly with ARC routing.Is there any alternate way to acheive this.