How to design X-Band 1:2 Microstip T-junction power divider in ADS

M

Manoj_N

Newbie
Joined
Nov 3, 2023
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
19
I wanted to design an X-Band 1:2 Microstrip T-junction power divider using ADS but I couldn't achieve the desired condition that is S(2,1) = S(3,1) = 0. Can someone help to solve this problem?
 

Sort by date Sort by votes
Hi!

Why do you need that condition? What is your input? port 1?
Regards
 

Upvote 0 Downvote
Manoj_N said:
Check the attachment. I designed the schematic.
View attachment 185964
Click to expand...
in a couple such as this, adding a 100 ohm chip resitor across the two outputs near the end of the two quarter wave lines WILL make it behave happier in your circuit. that is because if there are different load conditions for the two outputs, the resistor will absorb some of that mismatch power.
 

Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…