Thanks guys...i connect 1ohm resistor (25W) across V1 and across V2 connected 2.2ohm (25W).
THe result was not good. The V1 (5V) dropped to 4V and V2(12V) dropped down to 5V.
Any idea guys....do we have problem with the power supply? Or load set-up...remember the condition below....also V1 and V2 total current capacity is 40A, like thier load sharing...still really not clear to me...thanks a lot.
Conditions:
Total current available from V1 + V2 is 40 amperes, total current available from V3 + V4 is 6.6 amperes.
Minimum Load, V1 Min. load required to maintain regulation on V2 is 4 Amps
Minimum Load, V3 Min. load required to maintain regulation on V4 is 0.6 Amp