biswaIITH
Full Member level 4
hii folks...i am using a PIC16F876A micro..it doesnt have ne inbuilt DAC...How to check its ADC is properly working or not...I followed the approach below
i gave a reference of 2V inside the code...varied the input to the micro..in the code i gave a condition that if the input voltage was more than 2 then it would generate pulses of certain fixed frequency(set in code)....and it is showing the result...Is it the correct approach???
i gave a reference of 2V inside the code...varied the input to the micro..in the code i gave a condition that if the input voltage was more than 2 then it would generate pulses of certain fixed frequency(set in code)....and it is showing the result...Is it the correct approach???