How do you set grids in Altium library and schematic

Status
Not open for further replies.
T

treez

Guest
How do i set the grids (visiable and snap) to 0.1 inch in the library program....how do i change the units to inches.
 

How do i set the grids (visible and snap) to 0.1 inch in the library program
Click to expand...

press G, then enter your desired grids.

how do i change the units to inches
Click to expand...

press Q to toggle between imperial and metric
 
Last edited by a moderator:
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Thanks, but in the library editor, i set all the grids, electrical, snap, and visible to 0.1 inch, and then the screen grid lines are 10 apart....i am not sure where the 10 comes from when i selected 100 thou (0.1 inch)
 

did you zoom in enough to actually see the grid spacing? If you are zoomed out, it can look different.
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…