Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello,
you can draw the edges of the boundary surface that you looking for by drawing a boly line then make it a surface by cover surface , take care the polyline should be a closed contour. then define the boundry conditions.
regards,
Goher m_goher@yahoo.com
I believe you must have used HFSS for some time. I have been trying to build an on-chip spiral inductor but been facing many problem since. If you have time and dont mind to look it over, could you tell me what is the problem with my simulation? My files are posted at . Thanks a lot.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.