Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Horizontal AND vertical prong? why do this?

Status
Not open for further replies.

vlor

Junior Member level 2
Joined
Nov 15, 2010
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,479
Horizontal AND vertical prong? What can be attached to these?

Mini Water Fountain Pump | Virtual Village - US

Bought this pump and am going to be wiring it up to a transformer so I can plug it into the wall, but I was wondering why there are prongs like this at the end of the wires with plastic casing around them? What are these called and what can be attached to them?
 

It's just an arbitrary connector somebody picked, probably
this was originally a component for some larger system
where it made sense and now it's overstock on the Internet
bazaar. You could replace it with some other connector
type (crimp connectors from AMP, Molex, et al) or just
solder it up, whatever you want. If you go to some place
like Digi-Key (or any major electronoic distributor) you can
waste a day poring over connectors. Probably the single
largest category.
 

Huh, weird. I think I'll just cut it off, throw it away, solder the wires together, then wrap it up in electrical tape.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top