I need simple Low Side non isolated driver.
In terms of current, anything above 1.2A will pass.
I did a practical exam with what I had at hand.:laugh:
As clock source i use any fluke generator clock level 0/5V 12MHz rise/fall 4ns
This clock drive CMOS gate 74HCxx, TI say one gate on 6V drive 50pF load on 6ns , I use 4pcs ||,
it worked quite reliably on 6V.
Unfortunately, in the design I only have a 5.6V, 25V and more.
For good working on 5.6V was need 5 gate ||.
I look on
MIC4416
may be 7.5Ohm N and P MOSFET on output output stage current is good for me, input stage voltage logic level too. Where do I see the problem?
Delay Time, VCTL Rising 42ns in my opinion, it will omit pulses.