Signals shown above are just the examples of my real pwm signals. I showed like that because ı obtained pwm signals almost like this oscilloscope shown above. In my previous circuit, ı have used IR2106 but now ı am using IR2110. Oscilloscope signals are ground referenced. L1 and L2 are outputs of two TL494. H1 and H2 are inverted version of L1 and L2. H1 and H2 looks like normal but others not. When ı drive mosfets with like this driver circuit, my high side of mosfets become very hot even there is no load. Notice that now ı just want to use H1 and H2 signals for both low and high side mosfets. As you see, H1 and H2 will be input of drivers. is this possible ? All the gate signals should be like H1 and H2 ?
H1 and HI1, H2 and HI2 are same.