High side driver. No high voltage.

Status
Not open for further replies.
the motors I intend to drive eventually will have up to 100 V.
Click to expand...
No problem. Other than shown in the post #1 and post #15 schematic, H-bridge and gate driver must be supplied by seperate voltage sources. The gate driver ICs are prepared for this operation.

Please notice that supplying the driver IC with 24V as shown in post #15 will damage the FETs and possibly the driver IC. 12 to 15V is just fine.
 

I will get a lower voltage for the IR25601 and gates as well.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…