EyesOn
Newbie level 2
HI everyone
I want to simulate MOS noise
which are Thermal noise and flicker noise.
for approch this noise simulate , I am going to use Monte carlo simulation
in HSPICE.
I put the device variation like below
.tran 1us 100ms sweep monte=30
.param LENGTH=0.35u
.param LEFF=GAUSS (LENGTH, .05, 3)
(of course, this is length variation)
and.... I saw in HSPICE manual that AvanWave is able to calculate only the sum of results
The maunal said When you need to know every single curves, i must use .measure statement
Dose anyone have a idea about this?
how can I see every single curve?
am i doing very well? T.T
I want to simulate MOS noise
which are Thermal noise and flicker noise.
for approch this noise simulate , I am going to use Monte carlo simulation
in HSPICE.
I put the device variation like below
.tran 1us 100ms sweep monte=30
.param LENGTH=0.35u
.param LEFF=GAUSS (LENGTH, .05, 3)
(of course, this is length variation)
and.... I saw in HSPICE manual that AvanWave is able to calculate only the sum of results
The maunal said When you need to know every single curves, i must use .measure statement
Dose anyone have a idea about this?
how can I see every single curve?
am i doing very well? T.T