[HFSS] User Defined Model Simulation Error

Status
Not open for further replies.
M

minmin_J

Newbie
Joined
Jun 6, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
77
Hi, after I designed and placed my geometry .py code into the file of "UserDefinedModels" of ANSYS electronics desktop, I setup the lumped port Excitations and the analysis setup.

The design passed the validation, but when it came to the analysis process, it reported the following errors:

Code dot - [expand]
1
2
3
4
5
6
7
8
9
10

==================================================================================================
  HFSSDesign1 (DrivenModal)
    [error] Failed to refresh submodel __InductiveLink_65nm__1 (9:43:01 AM  Nov 29, 2019)
    [error] Body could not be created for part Passivation_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM  Nov 29, 2019)
    [error] Body could not be created for part ILD_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM  Nov 29, 2019)
    [error] Body could not be created for part Substrate_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM  Nov 29, 2019)
    [error] Body could not be created for part ILD_Tx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM  Nov 29, 2019)
 
..................
===================================================================================================================


The simulation stopped at the simulation beginning,

I could not find any .pfofile/.log file to check more information about these errors.

Can anybody help me resolve this problem? Thanks!
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…