Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help with SPI and I2C standards

Status
Not open for further replies.

eng_boody

Member level 3
Joined
Nov 27, 2011
Messages
57
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,754
hi people how are you,
hope you are fine

I'd like to ask you where Could I get Documents describing the Standards of SPI and I2C like
Commands on binary level , protocol in general , when a master sends a message to slave and
expects a reply what's the delay for response after the last master's bit is send , Registers and how to set ...etc.

the tutorials on the internet i have seen so far explain the principles without going deep into that standards details ..

thanks
 

andre_teprom

Super Moderator
Staff member
Joined
Nov 7, 2006
Messages
9,252
Helped
1,151
Reputation
2,321
Reaction score
1,133
Trophy points
1,403
Location
Brazil
Activity points
53,867
You could get precise information on specific devices datasheets rather than at generic tutorials. Moreover, you will note that in general SPI data frame formats varies from a device to another more than if compared to the same kind of function that uses I2C protocol.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top