hi friends I have designed patch antennas directional coupler in HFSS
when i start simulation it always give me error for "mesh"
When I solved examples from tutorials of HFSS it was not giving error.
I followed the same standard procedure for patch anenna design * simulation.
Hi.
In the Solution setuo-->option-->target must be less
or
Solution setup-->General-->Number of pass must be greater
or
Solution frequency must chosed right.
Have a good night. Bye.
Added after 13 minutes:
Hi.
The version of software may be don't act properly the soft ware is cracked and not suport this mesh.
bye