orcad reset part references
Thanks Acid Trap.
Oka, I have another problem with Orcad Capture.
For exmaple, I have 2 sheet of schematic in my design. On the 1st page of schematic, I have connected a pin to an "off-page connector" having a name "xxx". On the 2nd sheet of schematic, I also have a pin connected to a "off-page connector" having the same name as the 1st sheet "xxx".
Thus, how do I check their connectivity across 2 pages ? I have tried to highlight sheet 1 wire and right mouse click to "Select entire net". However, sheet 2 connection to "xxx" is not highlighted. Anything wrong with that ?
Thanks