Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

help needed in drilling details

Status
Not open for further replies.
V

vijaya_narayana

Full Member level 3
Full Member level 3
Joined
Jun 12, 2007
Messages
178
Helped
11
Reputation
22
Reaction score
1
Trophy points
1,298
Location
India
Activity points
2,184
can any body suggest me how to form a slot using orcad insted of drill holes one of the component that i am using has a rectangle Leg of 1mmX5mm
 

I don't use ORCAD, but it should be the same principle. What you need to do is draw a rectanle of the size and shape required using the dimension/mechanical layer or whatever the layer is called in ORCAD, it'll be the same layer as the outside of your board.
 

yah, I think he said it right.
 

Don't worry, normally PCB shop engineer can handle both cases for Gerber. That's really a piece of cake.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top