Help me with mixing the Tx and Rx signal then LPF in Matlab

Status
Not open for further replies.

gaboor

Member level 1
Joined
Mar 23, 2006
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,558
Hi,

Iam trying to do some analysis for a redar system that uses Linear Chirp modulation. I have a problem mixing the Tx and Rx signal then LPF. RX is a delayed version of the Tx. Normally after mixing (muliplying Tx and Rx) i dont get the low freq part!!!

I tried Matlab Help but i cannot get it!

Any help Please?
 

Re: Urgent: Matlab Help


How did you multiplied the two signals? are they sinosoidal functions? If so, you should obtain the low freq. component of the output of the mixer (multiplier).

Try it again, it may work,
Best Regards,
Ahmad,
 

Re: Urgent: Matlab Help

the signal are Chirp

here is the code

fsample=10000;
frmsz=512;
t = (1:frmsz)/fsample;
f = (1:frmsz/2)*fsample/frmsz;

y = chirp(t,500,frmsz/fsample,1500,'li');
figure
plot (t,y),
title('Transmitted signal')
xlabel('Time (seconds)')

x = chirp(t,500,frmsz/fsample,1500,'li',-240);
figure
plot (t,x);
title('Received signal')
xlabel('Time (seconds)')

z=x.*y;

Z=abs(fft(z));
figure
plot(f,Z(1:frmsz/2))

After i LPF the mixed signal (z) i exoect to get a sinosidal signal in the time domain!

Any idea?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…