Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help Me for Designing a Circular slot antenna in ADS

Status
Not open for further replies.

aniths

Newbie level 3
Newbie level 3
Joined
Dec 24, 2008
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,309
I've attached the pictures of the antenna containing both the front and backside pictures, also its geometry.
now i am doing my project in the layout window of ADS.
I don't know how to assign the substrate layers and metallization layers for it.
From the paper i understood that there are three layers viz.,
1. circular feed
2. substrate
3.circular slot.
Can anyone can help me in this regard?
 

Re: Help Me for Designing an open ended substrate in ADS

kspalla said:
Problem is not clear.
Now i have modified my doubts for to get answers from u.
 

As i understood u r using aperture coupling and using patch as metallized signal(ground plane) .But i suspect to use patch as ground plane. So deatails required. Or i assume that u connected ground wrong.(NO ground)
 

My understand is it is direct feed from 50 ohm as we can see the transmission line on one side and GND spread on the other side.
The beauty in this design is the edge of the path is made near to 50 ohm by the gnd open on the other end of circular path.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top