Re: impedance match
I already measure the impedance of analog input of AD converter.
The values are as following, respectively.
79-297j /32MHZ
51-234j /40MHZ
40-197j /48MHZ
How do I simulate it on ADS depends on the terminator is NOT at 50ohm?
Usually, I use TERM=50ohm at simulation-Sparam category.
But, I have no idea when the terminator is NOT 50ohm.
Added after 52 seconds:
I already measure the impedance of analog input of AD converter.
The values are as following, respectively.
79-297j /32MHZ
51-234j /40MHZ
40-197j /48MHZ
How do I simulate it on ADS depends on the terminator is NOT at 50ohm?
Usually, I use TERM=50ohm at simulation-Sparam category.
But, I have no idea when the terminator is NOT 50ohm.
Added after 56 seconds:
I already measure the impedance of analog input of AD converter.
The values are as following, respectively.
79-297j /32MHZ
51-234j /40MHZ
40-197j /48MHZ
How do I simulate it on ADS depends on the terminator is NOT at 50ohm?
Usually, I use TERM=50ohm at simulation-Sparam category.
But, I have no idea when the terminator is NOT 50ohm.