Hi jack,
personally, i use this technique, i don't know if it is the right or the faster one, but it works!
You may design yor RF subcircuit with your preferred RF simulation program (i use serenade and mwoffice), once got the RF layout, you export it in dxf format to make
it importable by Orcad (or your PCB design
program).
That's all. Once in Orcad, you can provide
connections between the RF subcircuit and
the other stuff (a control section, for example). Orcad in particular has not an RF components layout library, so you have to
design your own.
I repeat, this is my technique, there might
be better ways to do the same, but i hope this could help you.
Bye bye, have good!!
TomAss
P.S. For this info, make me a present...pm me a link to the animated gif of "walking felix" :smile: :smile:
<font size=-1>[ This Message was edited by: TomAss on 2001-11-16 09:15 ]</font>