Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HB- Simulation in ADS

Status
Not open for further replies.
Z

ZHazami

Newbie level 5
Joined
Nov 9, 2015
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
87
Hi!
I want to design a power amplifier and I know one of the simulations which should be run is HB simulation. I have started with the test circuit of the transistor. after finishing this step I tried to run HB- simulation. But for some reasons it couldn't be converged. I don't know exactly what is the source of these errors. sometimes it complains there is a problem with DC and some other times small internal timestep.

Does anyone have any comments?

Regards,
Zahra
 

HB Simulations are a bit tricky so you have to check the simulation setup, active devices models', circuit topology etc. Unless you haven't provided the whole project file with models, there will be just some intuitive help.
 

Hi!
Thank you for the reply. So could I send to you the ADS file of my simulation?

Regards,
Zahra
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top