Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

GSM configuration to receive call and message at the same time

Status
Not open for further replies.
D

djc

Advanced Member level 1
Advanced Member level 1
Joined
Jan 27, 2013
Messages
402
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,298
Location
India
Visit site
Activity points
4,554
Hi,

I want to configure my GSM modem to receive call and message at the same time. I am using VB6. I have configured the modem in form load event and sent the command to receive the call. Its working fine. but in the meantime i also have to keep on checking whether GSM modem sending any message or not. So where i should send the AT command for same. I am using VB6.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top