Araxnid
Newbie level 6
- Joined
- Aug 14, 2012
- Messages
- 11
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,366
I'm working on a project where i'm need to display the data through USB to Matlab. For example, to use an oscilloscope. Or data acquisition toolbox.
For example, to connect the ADC data received and transmitted via USB as an analog channel in simulink
I read the documentation, but did not understand whether there is any documentation for driver development? Some may come across?
I'm using a chip Vintsulum 2 as fpga-usb bridge and it can be replaced by something other.
What are the ways of communication? Even using the FTDI drivers? There is little experience with them, but without Matlab.
Is it possible to use DAQ toolbox without NI hardware? Or no?
For example, to connect the ADC data received and transmitted via USB as an analog channel in simulink
I read the documentation, but did not understand whether there is any documentation for driver development? Some may come across?
I'm using a chip Vintsulum 2 as fpga-usb bridge and it can be replaced by something other.
What are the ways of communication? Even using the FTDI drivers? There is little experience with them, but without Matlab.
Is it possible to use DAQ toolbox without NI hardware? Or no?
