Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

FTDI usb -> Matlab & Simulink

Status
Not open for further replies.

Araxnid

Newbie level 6
Joined
Aug 14, 2012
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,366
I'm working on a project where i'm need to display the data through USB to Matlab. For example, to use an oscilloscope. Or data acquisition toolbox.
For example, to connect the ADC data received and transmitted via USB as an analog channel in simulink
I read the documentation, but did not understand whether there is any documentation for driver development? Some may come across?

I'm using a chip Vintsulum 2 as fpga-usb bridge and it can be replaced by something other.

What are the ways of communication? Even using the FTDI drivers? There is little experience with them, but without Matlab.

Is it possible to use DAQ toolbox without NI hardware? Or no?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top