anvc
Newbie level 6
Hello all,
I am trying to simulate the frequency response of a simple rectifier using HB in ADS (Vdc x Freq). I have set the sweep variable to be the frequency of the power source of the circuit. When I perform the simulation, however, I get a constant dc output voltage which does not depend on the input frequency. Normally the cut-off frequency of such rectifier should be around 1GHz. Anyone can give a hint here on how to perform this simulation?
Thanks!
I am trying to simulate the frequency response of a simple rectifier using HB in ADS (Vdc x Freq). I have set the sweep variable to be the frequency of the power source of the circuit. When I perform the simulation, however, I get a constant dc output voltage which does not depend on the input frequency. Normally the cut-off frequency of such rectifier should be around 1GHz. Anyone can give a hint here on how to perform this simulation?
Thanks!