footprint in Allegro

Status
Not open for further replies.
Unzip the downloaded file.
Run the .bat file in that. Before that set psm and pad path in your .dra file in advance.
 
Thanks, I Run bat file . it just show pad , Finally , should I make a dra file ?
 

Before going to run .bat file do the following
Just open the empty .dra file and set the psm and pad path.
Move the unzipped file to the location which u mentioned for paths.
Run the .bat file.
It will work.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…