T
treez
Guest
Hello,
We are doing a footprint for the Osram “oslon square” GW CSSRM2 LED.
It will be mounted on IMS PCB. We wish to have a big thermal copper area connected to the pad. Page 15 of the datasheet gives some pad recommendation........but does not state the entire copper dimensions. They give copper recommendations for approximately an area of 6mm x 6mm.
What we wish to know is, is there likely to be any restriction to the placement of thermal copper beyond that approx 6mm x 6mm area shown?......or can copper be placed anywhere when beyond that 6mm x 6mm area?
Oslon square LED
https://dammedia.osram.info/media/resource/hires/osram-dam-5563433/GW CSSRM2.PM_EN.pdf
We are doing a footprint for the Osram “oslon square” GW CSSRM2 LED.
It will be mounted on IMS PCB. We wish to have a big thermal copper area connected to the pad. Page 15 of the datasheet gives some pad recommendation........but does not state the entire copper dimensions. They give copper recommendations for approximately an area of 6mm x 6mm.
What we wish to know is, is there likely to be any restriction to the placement of thermal copper beyond that approx 6mm x 6mm area shown?......or can copper be placed anywhere when beyond that 6mm x 6mm area?
Oslon square LED
https://dammedia.osram.info/media/resource/hires/osram-dam-5563433/GW CSSRM2.PM_EN.pdf