Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

filter design in ads

Status
Not open for further replies.
Run SP Analysis with activating calculation of group delay.

If you would like to evaluate group delay as post processing, calculate it like following.
group_delay = -diff(unwrap(phaserad(S12),pi) )/ (2*pi)

However, I don't recommend calculation by post processing.
 
Last edited:
Run SP Analysis with activating calculation of group delay.

If you would like to evaluate group delay as post processing, calculate it like following.
group_delay = -diff(unwrap(phaserad(S12),pi) )/ (2*pi)

However, I don't recommend calculation by post processing.

hi thanks for your guide , i am so sorry , but i dont know do this work and work with sp analyzer. Please get more guidance


Many thanks to
 


again,thanks
mr works that i do , at first design a filter with layout
. then simulate that and saw result .such as s12,s11 ,phase.smith
after that i performed from tools menu after SI/PI ANALYZER clicked
then , performed options in this window.
finally, clicked ok. then make a schematic , in this schematic i dont know what ?????
also i simulation s parameter palette and term component and in the simulation s parameter and in parameter tab i perform group delay option, after that i did simulation . unfortunately below error :

Simulation / Synthesis Messages

Warning detected by hpeesofsim during netlist flattening.
Cannot find substrate `MSub1'.
Error detected by hpeesofsim during netlist flattening.
`Cros1': Expected a substrate model for parameter `Subst'.

Status / Summary


hpeesofsim (*) 370.600 Mar 3 2011 (64-bit built: 03/09/11 08:31:42)
Copyright Agilent Technologies, 1989-2011.
--------------------
Simulation terminated due to error.
--------------------

please guide me .
thanks
 

Warning detected by hpeesofsim during netlist flattening.
Cannot find substrate `MSub1'.
Error detected by hpeesofsim during netlist flattening.
`Cros1': Expected a substrate model for parameter `Subst'.
Simply, necessary components don't exist in your schematic.

Show me your schematic.
 

Simply, necessary components don't exist in your schematic.

Show me your schematic.

today i dont have schematic in my office. tomorrow i show that to you. but when i selected sp/ip analyzer in layout and adjust options in this window , and after that a schematic was make and in this schematic perform group delay option .
do schematic was made isnot layouts schematic???
if isnot true , what do i do???

thanks
i will take to you my layout , tomorrow
 

It is very difficult to read your sentences.

Write sentences with grammatically correct English.[/QUOTE
please give me your email for send my layout and images performed group delay option
my email is g.kh1367@yahoo.com

thanks alot[/QUOTE
hi Mr
I also tried using the equation, but the error again. Please I really need your help
thanks

- - - Updated - - -

It is very difficult to read your sentences.

Write sentences with grammatically correct English.[/QUOTE
please give me your email for send my layout and images performed group delay option
my email is g.kh1367@yahoo.com

thanks alot[/QUOTE
hi Mr
I also tried using the equation, but the error again. Please I really need your help
thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top