I have circuit that receives IR signal, but single TFMS5360 dont cover whole area of IR beam impact zones, is there any possibility to attach few ir receivers (parallel ?) to this circuit? I tryed few tricks with 5 TFMS attached but it always end with failure.
I think there’s a problem if two sensors receive the same information simultaneously, but mounted in opposition (180 degree ) you may connect the two sensors in this way:
I think there’s a problem if two sensors receive the same information simultaneously, but mounted in opposition (180 degree ) you may connect the two sensors in this way:
Yup but i need to have full 360 degress cover of beam activation area, so i need to have 5-6 receivers, and they need to overlap cover areas, even as separated sensor circuit.