williamchia
Newbie level 6
Hi,
After following everything on the tutorial (URL: https://www.mikroe.com/en/books/picbook/4_07chapter.htm)
everything works all right, but when i try to assemble the file, this message comes out
" Executable code and data must be defined in an appropriate section"
I think i should be adding sth to the MPLAB or sth but what is it?
(I am using PIC16F877A instead of the one in the tutorial)
Thank you very much.
Regards,
William
After following everything on the tutorial (URL: https://www.mikroe.com/en/books/picbook/4_07chapter.htm)
everything works all right, but when i try to assemble the file, this message comes out
" Executable code and data must be defined in an appropriate section"
I think i should be adding sth to the MPLAB or sth but what is it?
(I am using PIC16F877A instead of the one in the tutorial)
Thank you very much.
Regards,
William