Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In Primary winding of the transformer, When we give 230V as the input, the stepped down output voltage will be obtained at the secondary winding of the transformer which will be given as the input for the rectifier circuit. I don't Know what voltage we will get at the secondary winding to be given to the input for the rectifier....
The voltage depends on the transformer, the ratio of the windings sets the input/output voltage relation so you design or buy a transformer based on your requirement.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
