Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Electronic compass solution

Status
Not open for further replies.

mingming

Junior Member level 3
Joined
May 30, 2001
Messages
29
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
South China
Activity points
173
I am looking for a low cost Philips KMZ52 digital compass solution. I need to find a suitable OTP MCU to start with (EMC or Holtek). Anyone has the calibration routine written in 4-bit or 8-bit MCU? How many bytes of RAM is needed for the routine if the accuracy requirement is about 4 degrees?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top