Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Electrical Resonace basics

Status
Not open for further replies.

timkuc

Junior Member level 2
Junior Member level 2
Joined
Jul 26, 2012
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,459
Electrical Resonance basics

Is it possible to gain infinite amplitude at resonance in practical situations in electrical circuit?( Please use example )
 
Last edited:

No, the voltage builds up until the power losses in the circuit equal the power input. I have built real circuits where the voltage across the tuned circuit was 100 times that of the input voltage. This required very special coils and low loss capacitors, it is about the maximum you can expect, most circuits the Q (voltage multiplication factor) can be taken as 100 or so. And of course when you go to use this voltage, you are loading the circuit, the Q falls and so does the available voltage.
Frank
 
A resonant circuit is not an amplifier. It simply converts impedances.
A parallel LC resonant circuit is a high impedance that produces a higher voltage when its load is a high impedance. A series LC resonant circuit reduces the voltage at resonance because it is a low impedance.
 
  • Like
Reactions: timkuc

    timkuc

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top