Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Electrical interface Marvell 88E1518

Status
Not open for further replies.
E

engr_joni_ee

Advanced Member level 3
Joined
Nov 3, 2018
Messages
750
Helped
2
Reputation
4
Reaction score
4
Trophy points
18
Activity points
6,232
Hi,

I need to know about the electrical interface of Marvell 88E1518 to the Ethernet connector. There are four differential signals i.e. MD1P, MD1N, MD2P, MD2N, MD3P, MD3N, and MD4P, MD4N. These signals has to be connected to the Ethernet connector. Are they LVDS ? Which signal standard do I need to use in routing ?
 

Refer to the datasheet. The MDI has integrated termination, thus you are routing 100 ohm differential pairs.

1607701908503.png
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top